• Clearance:

For 6-8 wide buildings we need 11' of height, the 6' Sidewall 13'.
All other buildings need 14' height.

On the width we need 2' more going straight in; more width is needed depending on how hard the turn is. The harder the turn the more width we need, and likewise the longer the shed the more width we need on turns. Please be prepared to give us as much space as possible. Shed sizes come in set sizes to best utilize the lumber. We have allowable limits to floor sizes, the 6 wide is a full 6 wide, the 8 wide is 93", the 10 wide is a full 10', 12 wide is 140", 14 wide is 161".

• Site Preparation:

Level off 4X4 or 4X6, treated timbers for a border around the outside and fill with 3/4 inch stone to the top of the border. Make your pad 6-12 inches more on the inside of your border than the size shed you plan to order, for better water drainage, to avoid dirt splash on shed and to simplify grass trimming. Keep your pad as low to the ground as possible, otherwise we cannot get your shed on your pad, we need at least 16 inches of clearance.

Showing a 12X20 Classic Line - w/Arch Doors $185.00- Vinyl Siding
Total Price $4115.00

Gable End
Example - proper access requires that the trees on this end be removed as this was the end we back in from.

Above is the preferred method of site preparation. The only mistake being very poor access. The shed is unloaded from the gable end and so we need access to drive out from the gable end, like you see in the picture below. Please make sure when choosing a site for your shed you give us proper access from the gable end.

Truck and trailer used for delivery